Finally had time to clean off the cosmoline(grease) today.
Spent half an hour on planning.
Pre fitted the barrel, bipod and magazine.
I need to run the barrel through a lathe to bore it about 3/4 diameter
to make room for the 10/22 barrel to slide through it.
Need to mill out the Bren lower receiver so the 10/22 trigger can drop right in
and I can get access to the 10/22 magwell
I dont plan on using the torched receiver parts. I plan on using sheet metal to reconstruct the receiver and just weld it until it fits the 10/22
Need to grind out the slag from the torch cuts.
Add a hinge to the receiver and side wall of the Bren so I can easily take out the 10/22
Plasti dip all the wood
Paint the rest of the gun flat black