"THE BUMBLE" My jeep build thread.

Post by **Tater Raider** » Thu Apr 15, 2010 5:44 pm

I'm enjoying the build. More! More!

Post by **Oneswunk** » Thu Apr 15, 2010 5:54 pm

Its going slow at the moment. Tomorrow ill finish my intake, then possibly Sunday I may finally get my lift on.

Post by **Hawk** » Sat Apr 17, 2010 11:22 am

Oneswunk wrote:Its going slow at the moment. Tomorrow ill finish my intake, then possibly Sunday I may finally get my lift on.

Awesome! Have you been periodically spraying everything with PB-Blaster for a while? Stuck bolts can turn a one-day job into a two day nightmare.
Wish I lived closer, I'd lend a hand.

Post by **FrANkNstEin** » Sat Apr 17, 2010 11:53 am

Awesome Jeep there!

Post by **Oneswunk** » Sat Apr 17, 2010 11:56 am

Ya bin spraying everything with kroil for a wile now. So hopefully Sunday will go easy, hell its only a bb and I have a new set of leafs for the back mine are sagging like crazy.

So to do...

Coil pucks up front and new shocks. (Tomorrow hopefully.)
Replace rear leafs and add aal and new shocks in back. (Tomorrow hopefully )
Pull some decent 31's out of my ass.
Get the okay to have some ZS magnets made for the sides. For advertisement at hopefully upcoming SEPA events and range trips.
Finish the heat shield for the intake.
Cap, rotor and wires.
May change dif fluid today depending on weather.
Herc the rest of the bottom sides of the Jeep.
OBA.
Bigger power inverter.

Eta, thanx.

Post by **Oneswunk** » Sun Apr 18, 2010 1:40 pm

Today did my front breaks and ditched the rest of my air box. Was going to fab up a heat shield and better hold down. But the wife had other plans for me. So for now a tie wrap will hold it still.

Still didn't work on the lift.

Post by **Tater Raider** » Mon Apr 19, 2010 9:15 pm

Dang Swunk... bummer on the lift. I hope you get to it soonish.

Post by **Oneswunk** » Mon Apr 19, 2010 9:32 pm

No worries I'll get it on soon.

Post by **Shaper** » Mon Apr 19, 2010 9:47 pm

Oneswunk wrote:No worries I'll get it on soon.

Nice job so far, swunk!

I miss my old XJ. I guess I will just have to live vicariously through you until I pick up another.

Don't know if you know about this site or not but I figured I would send it your way just in case...and lots of info for XJ owners...http://www.cherokeeforum.com/" onclick="window.open(this.href);return false;

And for good measure, lets not forget...http://www.jeepforum.com/forum/f11/" onclick="window.open(this.href);return false;

Post by **Oneswunk** » Mon Apr 19, 2010 9:58 pm

Thanx Sharp, I'm on CF as Delcozrt. Also have a build thread over there that I update along with this one.

Post by **ZombieSoldier01** » Fri Apr 23, 2010 9:50 pm

again looking bud, get the fawking lift on already...

wait what am i talking about i still gotta get my big block 460 started

Post by **Oneswunk** » Fri Apr 23, 2010 10:02 pm

Just have to pick up some V8 grand Cherokee coils and full size Chevy rear shackles and I'll be ready for the lift.

Post by **ZombieSoldier01** » Fri Apr 23, 2010 10:07 pm

Nice bud.. get 'er done

Post by **Oneswunk** » Sat Apr 24, 2010 6:41 pm

Finally found my noise.
Need a new track bar, pumped it full of grease and it came right out the side of the rubber. Wrapped that fucker with electrical tape, pumped it full and wheeled her a bit.

Quite now.

Now to pick up a new one.

Post by **ZombieSoldier01** » Sat Apr 24, 2010 7:13 pm

badass man..

Post by **Oneswunk** » Sat Apr 24, 2010 9:32 pm

Got back a wile ago from pulling my buddy out of the mud. Some people just don't listen, when I say your pos stock explorer isn't going to make it through that mud hole. Trust me its not going to make it. What's he do as soon as I leave he romps through it and gets his ass stuck.
Fucking ripped off one of my rear recovery points getting his ass out too.

O well I had fun.

Post by **DynamicRabbit** » Sat Apr 24, 2010 10:12 pm

Oneswunk wrote:Got back a wile ago from pulling my buddy out of the mud. Some people just don't listen, when I say your pos stock explorer isn't going to make it through that mud hole. Trust me its not going to make it. What's he do as soon as I leave he romps through it and gets his ass stuck.
Fucking ripped off one of my rear recovery points getting his ass out too.

O well I had fun.

I love friends who offroad and don't know how, then expect you to bail them out at 2 o'clock in the morning, from a spot dangerously close to where police patrol, because they aren't supposed to be offroading there in the first place.

Oddly enough, it was my explorer that pulled his Jeep Wrangler out. (I switched to a wrangler eventually though.)

Post by **Oneswunk** » Sat Apr 24, 2010 10:26 pm

well if he didn't have his kids with him I probably would have left his ass in the mud.
Even more pissed now, just realized I lost my S.O.G multi tool when I was hooking him up.

Post by **Oneswunk** » Sun Apr 25, 2010 3:05 pm

Be and my buddy were taking a wizz wile fishing yesterday. We almost bumped heads.

Post by **Oneswunk** » Thu Apr 29, 2010 1:27 pm

Trucks on its way to pick up my old explorer. $200 in my pocket.

Ill miss it we had some good times.
R.I.P you served me well, I beat you like a redheaded step kid.

Definitely a step up

Post by **Oneswunk** » Fri Apr 30, 2010 11:22 am

Yay for something to do after work.

And yay for my lovely wife sending me pix of fun stuff I get in the mail.

Post by **Tater Raider** » Fri Apr 30, 2010 2:37 pm

Sweet.

Post by **Blasphemous** » Fri Apr 30, 2010 5:16 pm

You need to return it... you're missing two wires and have the wrong cap

Post by **Oneswunk** » Fri Apr 30, 2010 5:45 pm

Ummmm no.

Its amazing how much smoother she's running.

All hail the blue wire.

Zombie Squad

"THE BUMBLE" My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.

Re: "THE BUMBLE" Build. project slow go. My jeep build thread.